Insulated Jacket Installation Manual

2
IMPORTANT: Before you build the frame, you must take into consideration the total weight of the liner, grill
and any  nishing materials.
Refer to the cutout dimension table for the proper framing dimensions for the insulation jacket. Determine
the entry point for both the gas inlet and electrical connections. Make the 4” square holes for gas and
electrical connections (rear or bottom access) based on your requirements.
Note: that the electrical connections are located on the left side and the gas connections are located on the
right side.
A Carpenter’s “spirit level” should be used to assure that the framing is level, both front to back and side to
side. Note: Never under any circumstance should you install the transformer or run a quick disconnect hose
inbetween the grill and the inside of the insulating jacket.
Liner Installation
Position the liner into the frame. No part of the combustible enclosure can protrude above the top surface
or in front of the face surface of the liner. Shim the liner if necessary.
Use the proper equipment to support the grill. Place the grill into the liner and engage it over the liner lip
across the back and sides. The liner is designed to support the grill without additional fasteners.
Grill Installation
If desired any gap remainng between the liner and the combustible enclosure may be  lled with a non-
combustilble sealant or caulk.