Installation Instructions

4
Regulator Conversion
LP
Orientation
NAT
LP
Natural
Orientation
NAT
LP
Apply sideways finger pressure
to remove pin from cap.
NAT
LP
conversion
conversion
•Remove hex nut from top of regulator.
•Unsnap plastic plunger from hex nut.
• Reverse plunger and reinstall onto hex nut by
pressing fi rmly.
NOTE: Plunger is marked “NAT” or “LP”.
Converted fuel type will be shown on the lower
portion of plunger.
• Reinstall hex nut onto regulator in confi guration
desired.
NOTE: VGR748 models have two regulators. Make sure both regulators
are converted. To access second regulator, the island trim and small panel
on the back must be removed
Second regulator located behind small
panel on VGR748 Gas Ranges.