Specifications

7
Feature #: Description:
1 Beacon/Strobe (factory default)
2 Strobe Only
3 Beacon Only
4
Strobe Brightness 1-6 (factory default = 6,
brightest setting)
5
Beacon Brightness 1-6 (factory default = 6,
brightest setting)
C. Programming Features List
Repeat
ON
ON ONOFF
ON OFF ON ON ONOFF OFF
OFF
0.10
sec
0.10
sec
0.10
sec
0.20 sec
0.10
sec
0.05
sec
0.025
sec
Typ.
0.025
sec
Typ.
8 Pulses
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
0.80 sec
OFF
0.80 sec
OFF
0.80 sec
OFF
0.80 sec
Repeat
Repeat
Repeat
Single
Flash:
Double
Flash:
Quad
Flash:
Flicker
Flash:
D. Strobe Flash Patterns
Feature #: Description:
6 Single Flash Strobe (factory default)
7 Double Flash Strobe
8 Quad Flash Strobe
9 Flicker Flash Strobe
10 Reset to Factory Default Settings
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
When the control module detects an incoming ring signal, it activates a set of normally open or normally closed con-
tacts and turns on the 12VDC output for activating the provided strobe light. With the Ring Cadence mode off (DIP
switch 2 OFF), the relay will activate and the strobe light will flash only during ringing. With the Ring Cadence mode
ON (DIP switch 2 ON), the relay will remain activated and the strobe light will remain flashing between rings.
A. Ring Indication (DIP Switch 1 ON)
When the control module detects an off-hook condition (“Help” button is pressed) on the brown and gray wires, it acti-
vates a set of normally open or normally closed contacts and turns on the 12VDC output for activating the provided
strobe light. The relay contacts will remain activated and the blue strobe light will flash during the off-hook condition
and will stop flashing approximately 3 seconds after the phone/terminal device on the brown and gray wires is back on-
hook. Note: A call initiated from the “Info” push button on the E-1600A-BLT2-EWP will not activate the strobe light.
B. Off-Hook Indication (DIP Switch 3 ON)