Specifications

11
Setting F - Pulse Dialing Rate (Pulses per second)
The 1600A series phone is capable of different pulse dialing speeds.
* Note: The factory default setting is 10pps.
Touch Tone
1
2
Setting F
10 pps*
20 pps
The 1600A series phone is factory set to automatically start playing the
voice announcement after it has determined the call has been answered.
Alternately, the announcement may be programmed to play after a pro-
grammed amount of time, from 1 to 99 seconds after dialing.
* Note: If the announcement delay time is used, you must allow enough time for the 1600A series phone to detect
ring-no-answer and busy signals when using the redial features. The factory default is set to play automatically.
Settings A and B - Announcement Delay
Touch Tone
00
01-99
Setting A/B
Play automatically
1-99 seconds*
G. Voice Announcer/Miscellaneous Options (memory location #17)
The 1600A series phones have a built-in non-volatile digital voice announcer that may be used to identify the location of the emer-
gency phone call. The 16 seconds of digital record time is recorded remotely from a Touch Tone phone. Programming options are
as follows:
Dial: A +B+C+D+E+F+#+1+7
Factory Default Setting:0+0 +1+2+ 1+0
Two Digit Announcement Delay {
Repeat Announcement Setting
Hang-up on Return to Dial Tone
Panasonic Mode
Lap Counter
Enter Settings Here:
A B C D E F
#17
If enabled and a busy is detected, the 1600A series phone will dial the next pro-
grammed emergency speed dial number, and continue to cycle through the emer-
gency numbers until a call is completed. * Notes: This feature is enabled in the
factory default setting. If the busy signal is interrupted with a promotional mes-
sage, contact your central office to have it removed.
Setting E - Dial Next Emergency Number on Busy
Touch Tone
1
2
Setting E
Disabled
Enabled*
If enabled and a return dial tone is detected, the 1600A will hang up.
* Note: The factory default setting is enabled.
Touch Tone
1
2
Setting D
Disabled
Enabled*
Setting D - Hang Up on Return to Dial Tone
The 1600A can be programmed to play the announcement from 1-9 times,
or to continuously repeat the announcement every 8 seconds until a
Touch Tone
Q is detected from the distant party. The call connected LED
will turn on automatically after the announcement has stopped repeating.
* Note: The factory default for the 1600A series phone is to play the voice announcement once (digit 1).
Touch Tone
0
1-9
Setting C
Repeat every 8 secs
Repeat 1-9 times*
Setting C - Repeat Announcement Option