Installation Guide

8 EN
Refrigerator / User Manual
Installation
Electrical connection
• Electrical connection must comply with national and
local regulations.
• Power cable plug must be within easy reach after
installation.
• The specified voltage must be equal to your mains
voltage.
• Do not make connections via extension cables or
multi-plugs.
WARNING: Damaged power cable must
be replaced by the Authorized Service
Agents.
WARNING: If the product has a failure, it
should not be operated unless it is repaired
by the Authorized Service Agent! There is
the risk of electric shock!
Adjusting the feet
If the product stands unbalanced after installation adjust
the feet. If the unit is in an alcove then the unit may
need to be rolled out of the alcove to be able to tilt the
unit back to adjust the feet. Use another person to safely
tilt the product during this process.
WARNING: First unplug the product.
Product must not be plugged in when
adjusting the feet. There is the risk of
electric shock!
Turn the front feet to balance the product. The corner
where the foot exists is lowered when you turn in the
direction of arrow and raised when you turn it in the
opposite direction.
LED Lighting
Do not attempt to repair yourself. Call an Authorized
Service Agent if the LED lights do not go on or are out
of order.
The lights used in this appliance are not suitable for
household room illumination. The intended purpose
of this light is to assist when loading food in the
refrigerator/freezer in a safe and comfortable way.
Door Alarm
An audio warning signal will sound when the door of
your product is left open for 1 minute. This warning will
be muted when the door is closed or any of the display
buttons (if any) are pressed.
Remove the two screws at the top of the grille. Add the air
buffer bumpers using the screws that were removed from
the related holes on the product or the screws come together
with the buffer bumpers.