Installation Guide

14 EN
Refrigerator / User Manual
• To allow the refrigerator compartment keep its ideal
storage temperature, sensor must not be hindered by
food.
Before using the product, check that all preparations are made
in accordance with the instructions in sections "Important
instructions for safety and environment" and "Installation".
• Clean the interior of the refrigerator as recommended in the
“Maintenance and cleaning (Page 25)” section. Check that
inside of it is dry before operating it.
• Plug the refrigerator into the grounded wall outlet. When the
door is opened the interior illumination will turn on.
• Run the refrigerator without putting any food for 6 hours and
do not open its door unless absolutely required.
• Do not allow the food to touch the temperature sensor in
refrigerator compartment.
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running and this is quite normal.
Front edges of the refrigerator may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
Installing Door Handle
1. Place the handle over the pin joints that are on the door
panel.
2. Using the supplied 3 mm allen key, tighten the screw to
a tightness where the handle does not move from the pin
joints pin joints may need to be loosened and tightened
back up for realignment to make the door handle to fit
correctly.
3. Tighten both sides evenly and do not overtighten.
Preparation
5
The ambient temperature of the room
where you install the refrigerator should
at least be 50°F/10ºC. Operating your
refrigerator under cooler conditions than
this is not recommended.
Inside of your refrigerator must be cleaned
thoroughly.