Installation Guide

11 EN
Refrigerator / User Manual
Installation
Before using the water/ice dispenser
• Water system of the refrigerator must be connected To
the cold water line.
It must not be connected to hot
water line.
• No water may be obtained in the initial start-up of
the refrigerator. Because there is air in the system. To
discharge air from the system, press dispenser for 1-2
minutes until water comes from the dispenser. Water
flow may be irregular at the beginning. After the air in the
system is discharged, water flow will return to normal
place container under dispenser nozzle.
• The first 10 glasses of water should not be consumed.
• During initial use, you will have to wait approximately 12
hours to cool the water.
• It will take around 1-2 days for the system to produce
required amount of ice.
• If the water dispenser is not used for a long period of
time, first 1-2 glasses of water can be hot.
• If a power outage or a temporary failure occurs while the
refrigerator is operating, ice can melt down a little bit and
then get frozen again. In such a case, ice cubes can stick
to each other. If the outage or failure prolongs, ice can
melt down causing water leakage. If you experience such
a problem, empty and clean the ice container.
• Ice cubes can stick to each other if they are left in the
container for a long time.
• The water system installation of the refrigerator must be
performed by the Authorized Service Agent.
• If the product is to be connected to the water mains,
make sure that you use potable water.
• Water system of the product is designed to operate only
with water. Do not use beverage such as soft drinks and/
or juices in the water system.
• It is recommended that the water is disconnected if you
will not be using the refrigerator for a long period of time
due to vacation or similar reasons.
• Do not attempt to dismantle the ice container group
assembly parts.
• Do not attempt to clean the ice container assembly
without removing it from the refrigerator.
• When taking water from the water dispenser, remove
the glass from the opening 1 second after releasing the
trigger. Thus, water in the system will not drip into the
drip tray.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water connections.
3. Secure the shelves, accessories, and drawers. in the
refrigerator by adhesive tape before repackaging it.
Packaging must be tied with thick tapes or
strong ropes and the rules of transportation
printed on the package must be followed.
Original packaging and foam materials
should be kept for future transportations.
WARNING: Packaging materials
are dangerous for the children. Keep
packaging materials in a safe place away
from reach of the children.