Installation Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Website at vikingrange.
Table of Contents IMPORTANT– Please Read and Follow Warnings & Important Safety Instructions _______________________________________________3 Dimensions _________________________________________________________________________5 Specifications _______________________________________________________________________6 Cutout Dimensions __________________________________________________________________7 Clearance Dimensions (Proximity to Cabinets) ___________________________________________8 Clearance Dimensio
IMPORTANT– Please Read and Follow WARNING CAUTION BURN HAZARD Dimensions 30” Electric Cooktop 36” Electric Cooktop Be sure the electric power is off from the breaker box to the junction box until the cooktop is installed and ready to operate. The junction box should be connected to a suitable ground. The use of cabinets for storage above the appliance may result in potential burn hazard. Combustible items may ignite, metallic items may become hot and cause burns.
Specifications Cutout Dimensions Electric Cooktop Description RDECU106 30”W RDECU166 36”W RDECU256 45”W Overall width 30-3/4” (78.1 cm) 36-3/4” (93.3 cm) 45” (114.3 cm) 4-1/2” (11.4 cm) Overall depth from rear 21” (53.3 cm) 28-7/8” (73.3 cm) 29-7/8” (75.9 cm) 34-7/8” (88.5 cm) 35-7/8” (91.1 cm) Cutout height with conduit 43-1/8” (109.5 cm) 44-1/8” (112.1 cm) 20” (50.8 cm) 20-1/4” (51.4 cm) Electrical requirements 240/208v 50/60hz 240V—40.0 amps 208V—34.6 amps C 4-1/8” (10.
Clearance Dimensions Proximity to Side Cabinet Installation (Proximity to Cabinets) Minimum Clearances from Adjacent Combustible Construction • The cooktop may be installed directly to existing base cabinets. • The cooktop CANNOT be installed directly adjacent to sidewalls, tall cabinets, tall appliances, or other side vertical surfaces above 36” (91.4 cm) high. There must be a minimum of 6” (15.2 cm) side clearance from the cooktop to such combustible surfaces above the 36” (91.4 cm) counter height.
Electrical Requirements General Information Electrical Requirements READ AND FOLLOW ALL WARNING AND CAUTION INFORMATION WHEN INSTALLING THIS APPLIANCE. Electrical Connection Check your local codes regarding this unit. This cooktop is supplied with a 3-wire, A.C. 208Y/120 volt or 120/240 volt, 60 HZ electrical system. A white (neutral) is not needed for this unit. See next section for grounding instructions. It should be fused separately.
Installation 1 Final Preparation 2 Green Neutral • Some stainless steel parts may have a plastic protective wrap which must be peeled off. • All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed for this material. If buildup occurs, DO NOT use steel wool, abrasive cloths, cleaners, or powders! Red Black Lower cooktop into cutout. Connect the red and black leads from the unit conduit to the corresponding leads in the junction box.
Service & Registration Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to: VIKING RANGE CORPORATION PREFERRED SERVICE 1803 Hwy 82W Greenwood, Mississippi 38930 USA The serial number and model number for your appliance can be found by looking under the cooktop.
