Installation Guide Range/Rangetop Rear Trim Accessories & Range Curb Base Fronts
Rear Trim Accessories All rear trim devices are installed in the same basic way. ATTACHING REAR TRIM (Illustration I) Grasp the trim on each end and carefully place in the channels (B) located at each rear corner of the product. Align the screw holes (A) at each end of the trim device with the holes (A) in each rear channel of the product. Secure with the 4 enclosed screws.
Rear Trim Accessories ATTACHING BACKGUARD (Illustration III) Backguards come equipped with Nylon Spacers (See Figure 1), which are needed to space the range off a combustible wall a prescribed safe distance. (Illustration III) Note: If the back wall is NonCombustible, these spacers can be removed.
Rear Trim Accessories Custom VGIC ranges and 60” VGCC ranges require that two 1” standoff spacers be attached to the back of the range when using a range with a backguard against a combustible surface. (See Figure 4) Figure 4 Once you determine whether or not your product needs the provided spacers, the backguard is ready to be attached. Simply slide the backguard down onto the rear of the unit and attach using the (4) screws provided.
Curb Bases STANDARD CURB BASE FRONT 1. The standard curb base front (A) is completely assembled. 2. Remove the assembly from the carton and simply clip onto the front range legs. 3. The assembly is adjustable about 2” (5.1 cm) front to back so that alignment with the cabinet toe front is possible. Loosen brackets on each side, but allow snug fit. Clip assembly onto range legs; determine front to back setting; remove, tighten bolts, and reattach.
Curb Bases CUSTOM CURB BASE FRONT 1. Remove the standard curb base front assembly from the carton. 2. Remove the front (A) from the mounting assembly (B). 3. Attach locally supplied front (C) to the mounting assembly (B) and simply clip onto the front range legs. Important Note: The locally supplied front must not be any taller than 3-1/8” (7.9 cm) tall. Fronts taller than 3-1/8” (7.9 cm) could obstruct the airflow. 4. The assembly is adjustable about 2” (5.
Curb Bases COUNTERTOP REAR TRIM 1. Locate screw hole openings (A) on back of island trim near the top. 2. Align screw hole openings on countertop rear trim with the ones on the back of the island trim. 3. Attach rear trim to island trim with enclosed screws.
Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information call 1-888-845-4641 F1448N EN (100113)
