Specifications

6
BACK TRIM ACCESSORIES
Assembly and installation instructions are included with all back trim accessories.
ANTI-TIP STABILITY DEVICE INSTALLATION INSTRUCTIONS
1. The anti-tip bracket is to be attached to the rear wall as shown. The dimension for the bracket location from the
floor is to be determined after the range legs have been adjusted to the proper installation height shown in the
installation instructions and the range has been leveled.
2. Measure from the floor to the bottom of the anti-tip opening located on the back of the range.
3. Locate the anti-tip bracket on the wall at the measure dimension plus 1/16” (0.16 cm) clearance and attach securely
with provided toggle bolts.
4. Slide range into place. Be sure the bottom rear flange on the rear of the range slides under the bracket attached to
the rear wall.
Item “A”
Item “A”
Figure 1
Figure 2
Item “B”
Bottom rear flange
To be determined after the range legs have been adjusted.
RANGES EQUIPPED WITH CASTERS
1. Adequate means must be provided to limit the movement of
castered ranges without depending on the connector and/or
quick disconnect device. This “restraint” should be
inspected as part of the maintenance and safety procedure.
Restraint cable must be connected at all times when range is
in use.
2. When using the quick disconnect device and/or casters, the
“restrainer” must be attached to the wall and to the rear of
the range.
3. If disconnection of the restraint is necessary, ensure the
restraint is reconnected after the range has been returned to
its original position.