Specifications

B. System Requirements
C. Installing Software
D. Un-Installing Software
MODEL PB-100
VIKING ELECTRONICS, HUDSON WI 54016
1 2 3 4
1 2 3 4
POLLING BRIDGE
ON
OFF
RESET
STATUS
VIKING©
P
P
r
r
o
o
g
g
r
r
a
a
m
m
m
m
i
i
n
n
g
g
Step 1. Connect the hardware as shown in “Hardware Installation”.
Step 2. Insert the Viking master CD to start the program.
Step 3. Follow the instructions on the CD.
Step 1. Go to “Control Panel”, then select “Add/Remove Programs”.
Step 2. Select the Viking software you want to remove.
Step 3. Click “Remove”.
Note: If you have disabled the “Auto-Run” feature on your computer and the CD does not automatically start, double
click the setup.htm file in the root directory of your CD-Rom drive.
1. Hardware Requirements
• Internet Explorer or Netscape Navigator Version 4 or newer to navigate CD contents.
• Adobe Acrobat Reader® version 4.x or newer to view Product and Software Documentation.
• Microsoft
® Visual Basic version 6 or newer to change, edit, compile, or publish the supplied source code.
• A license for the Sax Software Comm Objects serial communication driver to change, edit, compile, or publish
the supplied source code.
2. Software Requirements
• IBM Compatible personal computer with: Windows 95, 98 or ME (with OLE32 updates), Windows NT 4.0 (service
pack 6 or higher), Windows 2000 (service pack 2 or higher).
• PB-100 hardware.
• Available RS-232 serial port.
• Male sub-D 9 pin cable (provided with PB-100 hardware).
• Windows compatible sound card.
• 5MB minimum free hard drive space for each installation.
• 8MB of free physical RAM for each Viking application running.
Switch
1
1
2
2
3
4
ON/OFF
OFF
ON
OFF
ON
-
-
Description
1600A Series polling mode enabled
1600A Series polling mode disabled
AES-2000 programming disabled
AES-2000 programming enabled
(not used)
(not used)
Smart Terminal is diagnostic program that allows the user to send and receive data directly to COM1 or COM2 of
your PC. ASCII, Hex and Decimal data can be entered, decoded and sent out the selected ports. Two separate
display areas allow the user to view data coming in on either port. This utility is useful for troubleshooting the con-
nection between the PB-100 and your PC. If an “H” followed by Enter is received by the PB-100, it will send back
a “K” and a carriage return. Do this to assure you have the correct com port configured for the PB-100. For more
information, retrieve Fax Back Document 863.
5. Smart Terminal Diagnostic Software
The Information Provider turns the PB-100 and your PC into a multiple message ring trip announcer. The software
allows you to organize messages into multiple menu levels (up to 10). The announcements can be any wave
(.wav) file stored on your computer's hard drive. When a call is answered by the PB-100, the software starts the
"answer" announcement. This message should contain a greeting as well as a menu for further message or menu
selections via user selectable DTMF Touch Tones. Each of these messages can contain additional menus for
even deeper levels of messages. The maximum number of announcements per level is 12 and the maximum num-
ber of menu levels is 10. The software can also perform a blind transfer (hook flash transfer) on a programmable
Touch Tone command as well as a simple hang up. The Information Provider software provides an easy to follow
spread sheet like display for organizing the messages and transfer functions. For more information, retrieve Fax
Back Document 862.
4. Multi-Message Information Provider Software