Operation Manual
51
DEFRNLITESPTNOSVFIDAPLSKTRHU EN
0478 131 9917 G - EN
Transporting STIHL batteries:
STIHL batteries meet the requirements
specified in UN manual
ST/SG/AC.10/11/Rev. 5 Part III,
subsection 38.3.
The user may transport STIHL batteries by
road to the place of use of the machine
without further restrictions.
Country-specific legislation must be
observed in the case of air or sea
transport.
For further transport instructions, see
www.stihl.com/safety-data-sheets
REACH:
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals. For information on
compliance with the REACH Directive
(EC) No. 1907/2006, see
www.stihl.com/reach
Fault:
Motor will not start
Possible cause:
– Battery not fully charged (one green
LED flashes on battery)
– Battery incorrectly inserted
– Safety plug is not inserted
– Start button not pressed
– Motor is overloaded because the grass
is too tall or too wet
– Motor overload protection activated
– Battery too cold or too warm (one red
LED illuminates on battery)
– Battery too warm (three red LEDs
illuminate on battery)
– Humidity in machine and/or battery
– Mower housing is blocked
– Fuse in safety plug defective
- up to 100 %
capacity 25 min
Charging time for AP 120:
- up to 80 % capacity 30 min
- up to 100 %
capacity 60 min
Charging time for AP 160:
- up to 80 % capacity 35 min
- up to 100 %
capacity 60 min
MA 339.0 / MA 339.0 C:
Serial number 6320
Motor, design Electric motor
Manufacturer Domel
Type EC motor
Voltage 36 V
Power input 600 W
Protection class III
Type of protection IPX 0*
Cutting utilities Cutter bar
Cutting width 37 cm
Speed of cutting
utilities 3100 rpm
Cutter bar drive permanent
Tightening torque for
blade fastening
screw 10 - 15 Nm
Wheel diameter
(front) 150 mm
Wheel diameter
(rear) 180 mm
Grass catcher box 40 l
Cutting height 30 - 70 mm
Cutting height (Great
Britain only) 20 - 70 mm
In accordance with Directive 2000/14/EC:
Charger AL 500:
Guaranteed sound
power level L
WAd
90 dB(A)
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L
pA
77 dB(A)
Uncertainty K
pA
1dB(A)
* Protection objective IPX 1 achieved
through use of suitable components.
MA 339.0:
Specified vibration characteristic in
accordance with EN 12096:
Measured value a
hw
0.63 m/sec²
Uncertainty K
hw
0.32 m/sec²
Measurement in accordance with
EN 20643
L/W/H 122/42/107 cm
Weight (without
battery) 12 kg
MA 339.0 C:
Specified vibration characteristic in
accordance with EN 12096:
Measured value a
hw
1.02 m/sec²
Uncertainty K
hw
0.51 m/sec²
Measurement in accordance with
EN 20643
L/W/H 128/42/107 cm
Weight (without
battery) 13 kg
MA 339.0 / MA 339.0 C:
20. Troubleshooting
# If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.