Viking Use/Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at 24” Wide Undercounter/Freestanding Refrigerated Beverage Center vikingrange.
IMPORTANT - PLEASE READ AND FOLLOW • • • • • Before beginning, please read these instructions completely and carefully. Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty. Please observe all local and national codes and ordinances. Please ensure that this product is properly grounded. The installer should leave these instructions with the consumer who should retain for local inspector’s use and for future reference.
SPECIFICATIONS/DIMENSIONS DESIGNER SERIES GENERAL INFORMATION Front View Unpack 1. Remove banding from bottom of carton. Lift carton up and off of the unit. 2. Remove all tape and packaging material from the outside and inside of the cabinet. 3. Keep all carton packaging until your refrigerated beverage center has been thoroughly inspected and found to be in good condition. Basic Electric Data •115 VAC/60 Hz •Maximum amps - 3.3 •Approximate shipping weight - 140 lbs (63.2 kg) Mín. 34 1/4” (87.
CUSTOM WOOD FRAME INSTALLATION INSTRUCTIONS (DFUR MODEL) Selecting and Preparing the Wood Frame (DFUR MODEL) FOR A 3-1/2” TOE KICK (COVERS THE ENTIRE DOOR EXTRUSION) Note: Weight of wood panel must not exceed 20 lbs. Wood Screws 1. A #10 pan head wood screw should be used to properly secure the wood frame. A total of 10 screws will be needed for a 3 1/2” (8.9 cm) kickplate or 8 screws for a 4” (10.2 cm) kickplate. 2. Only use pan head screws. Working Material Wood Screw Size #10 3.
Attaching the Handle Attach the handle of your choice by drilling mountingholes through panel. Countersink or counterbore holes from back side of panle for handle screw heads to be flush Attaching the Wood Frame to the Door (DFUR MODEL) 1. If the door is attached to the unit, remove by unscrewing the top allen head set screw at the top hinge. Remove the door by angling the door off of the bottom hinge pin. 2. Peel back the door gasket to expose the screw holes. 3.
FINAL PREPARATION OPERATING INSTRUCTIONS 1. Some stainless steel parts may have a plastic protective wrap which must be peeled off. The interior of the refrigerated beverage center should be washed thoroughly with hot, soapy water, rinsed and wiped dry to remove film residue and any installation dust or debris before being used. Solutions stronger than soap and water are rarely needed. 2. All stainless steel parts should be wiped with hot soapy water.
CLEANING AND MAINTENANCE SERVICE INFORMATION Any piece of equipment works better and lasts longer when maintained properly and kept clean. It is assumed that your refrigerated beverage center has been properly installed in accordance with all specifications and local codes and the appliance has been properly grounded. If your refrigerated beverage center should fail to operate, review the troubleshooting chart before calling for service.
BUILT-IN UNDERCOUNTER/FREESTANDING REFRIGERATED BEVERAGE CENTER WARRANTY (Units certified for Outdoor Use) ONE YEAR FULL WARRANTY BUILT-IN UNDERCOUNTER/FREESTANDING REFRIGERATED BEVERAGE CENTER WARRANTY (Units certified for Indoor Use) TWO YEAR FULL WARRANTY Built-in/freestanding undercounter refrigerated beverage centers and all of their components and accessories, except as detailed below*, are warranted to be free from defects in material or workmanship under normal household use for a period of one (1
