Specifications

12: Common
11: Emergency Siren (Yelp): Continuous while
shorted to pin 12 (common).
10: Evacuation Sound (Temporal Slow Whoop):
Continuous while shorted to pin 12 (common).
9: Doorbell Chime Sound (Ding Dong):
One chime per closure.
8: N.O.
7: COM Relay Contact
6: N.C.
5: N.O.
4: COM Relay Contact
3: N.C.
1 & 2: 600 Ohm Audio Out Pair: Line level output,
connect to input of paging amplifier.
PM
TIME
/
CANCEL
-
+
MODE
ALERT TONES
SINGLE
DOUBLE
TRIPLE
VIKING ©
MODEL CTG-1
LOCK
SET DAY
SET TIME
SET EVENTS
REVIEW/CANCEL
CLOCK CONTROLLED
TONE GENERATOR
VOL
9V BATTERY
BACKUP
123456789101112
12
ON
ON
OFF
60 Hz
(installed)
50 Hz
(removed)
F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
O
O
v
v
e
e
r
r
v
v
i
i
e
e
w
w
Clock and Event Time Setting Buttons: Press the + or
-/CANCEL buttons to increase or decrease time. The -
/CANCEL switch is also used to cancel an alert tone
event when reviewing programming.
Alert Tones Programming Buttons:
After setting an event time, press SIN-
GLE, DOUBLE or TRIPLE to program
1, 2 or 3 alert bongs/buzzer sounds for
that event time.
Secondary Button Functions While
in the SET DAY Mode: The SINGLE
button is used to select between day (1-
7) or on/off. The DOUBLE button is
used as a one time setup to program
today’s day of the week.
DIP Switches and Shunts:
See Programming section J.
Mode Button: Press to place the CTG-1 in the Lock,
Set Time, Set Day, Set Events or Review/Cancel modes.
9V Battery Backup Connection: A standard
rechargeable (NiMh) 9V battery is installed to
maintain the clock time during power outages.
CTG-1 Output Volume Control: Turn clockwise
to increase volume of alert bongs/buzzer sounds,
emergency and door bell (chime) sounds (see
Installation section).
Display: Shows
clock, event time
and mode settings.
* Note: When the buzzer alert tone is programmed, a double or
triple programmed event will be sounded twice, approximately
three seconds apart.
3