Service manual

PULL DOWN MENUS
4-2
Month 2000
Part No. 001-2004-601
4.3 EDIT
This menu is used to create new files and set or
change the repeater operating parameters. The file-
name for the Locality and relevant data is shown in the
Title Bar and Status Bar (see Section 4.8.1).
Figure 4-5 EDIT MENU
4.3.1 LOCALITY INFORMATION
This menu selection has an equivalent icon in the tool-
bar. This menu selection or icon brings
up the Locality information screens to
Define Repeaters and Adjacent Locali-
ties.
Figure 4-6 LOCALITY CONFIGURAITON
Figure 4-4 EDIT PROGRAMMING FLOWCHART
Define Repeaters
Adjacent Locality Data
Edit Parameters
General Parameters
Select Repeater
Repeater Information
EDIT
Locality Information
Delete Repeater
Input Alarms
Output Alarms
Alarm Cross Reference
Table 4-1 DEFINE REPEATERS PARAMETERS
Delete Entry Removes the selected Defined Repeater from the list.
Frequency Band Selects the Locality frequency band, 380 MHz Base, 430 MHz Base or 470 MHz Base.
Transmit Frequency Enter the transmit frequency within the band selected.
Receive Frequency Enter the receive frequency within in the band selected.
Area Bit If the coverage area includes more than one Switch the area bit is used, this is normally 0.
Active Click on this box to activate the selected Defined Repeater.
Defined Repeaters Click on a repeater number, then select the channel number and the data is displayed.
Compand Click on this box if the Companding option is used.
BW Limited Default is 25 kHz bandwidth, click on this box to select 12.5 kHz bandwidth.
OK Saves the current selections shown and closes the window.
Cancel Disregards all changes and closes the window.
Help Displays the Help screen for the parameters in this window.