- Viking Vehicular Gate Operator Installation Instructions

TECHNICAL SUPPORT 1 800 908 0884
28 28
SPECIAL FEATURESSPECIAL FEATURES
Inside
Outside
Opens First
Slave UnitMaster Unit
MAG
LOCK
Mag. Lock
UL
Siren
Radio
Rec.
UL
Sensor
Safety
Loop
Charger
Brake
Fail Safe/Secure
Slave
Fail Safe/Secure
Master
Master Open Slave Open
Master Slave
Power
Low Battery
Slave
Limit Open
Limit Close
Slave
Limit Open
Limit Close

Inside

Outside

Inside

Outside
Radio StationSafety ConnectorOpen CommandsGuard Station
Close Stop Open Gnd Fire Gnd Strike Gnd Exit Gnd Center Gnd Safety Gnd UL Gnd +28v Gnd Radio Gnd +28v +28v
N.O. COM N.C.
Obstruction
Sensor
Overlap Delay
1.5
Center
Loop
Hold Open
Timer
StopClose Open
Limit Limit
30sec
60sec off
1sec
03
A Master/Slave control board is required to
operate two gates with a single controller.
Gate Overlap Setting
Setting the Overlap Delay Pot to any value
other than zero will cause the master unit to
delay in opening.
The time delay can be set for up to 3 seconds.
Setting the Overlap Delay Pot to “0” will cause the master and the slave units to
open and close at the same time
Trim Pot Location
(Master/Slave Unit Board shown)