Specifications

TECHNICAL SUPPORT 1 800 908 0884
6
WARNING - Not following these instructions may cause severe injury or death to persons.
IMPORTANT SAFETY INFORMATIONIMPORTANT SAFETY INFORMATION
Photo Beam (non-contact sensor) Installation
Gate in Closed Position
Photo Beam Unit
Reflector
Potential Entrapment
Area (Shaded)
Contact Sensor Contact Sensor
Radio St
a
Ma
g
Safety Connectorands
io Station
Safety Connector Ope
n
Gnd Exit Gnd Center Gnd Safety Gnd UL Gnd +28v Gnd Radio +28v
Ma
g
.
One or more non-contact sensors shall be located where
the risk of entrapment or obstruction exists, such as the
perimeter reachable by a moving gate or barrier.
Consult the installation manual for the UL325 device
(photo beam or like) for detail information about the
usage, installation and maintenance
1
(C1)
3
(NC1)
24VDC
1
(C1)
3
(NC1)
24VDC
Turn Switch to
'Light On' Position
24 VDC Power Connections
24 VDC Power Connections
Omron Model
E3K-R10
Shown
Connection '3' (NC1)
Connection '1' (C1)
Photo beams or like must be installed to reduce the risk of entrapment.
Use only UL325 compliance devices like:
Omron E3K-R10
Ensure that any device installed is UL325 compliant and low voltage device (24 VDC).
Read the device manual for proper installation, and proper connection (especially
the polarity of the device).