Specifications

TECHNICAL SUPPORT 1 800 908 0884
1516
LIMIT SWITCH SET-UPLIMIT SWITCH SET-UP
OPEN RIGHT
Upper Cam sets
Close Position
Lower Cam sets
Open Position
OPEN LEFT
Upper Cam sets
Open Position
Lower Cam sets
Close Position
Lower Cam
Lower Limit Switch
Upper Limit Switch
Set Upper Cam
in the Direction Shown
Set Lower Cam
in the Direction Shown
Upper Cam
STEP 1
Set the Fine Tune Limit Pot to zero on the Control Board.
This ‘Trim Pot’ can be
used to FINE ADJUST the
closing position of the
gate with a high degree
of accuracy (up to 1/16”).
The number on the Trim
Pot dial sets the number
of inches the gate travels
after initial set-up.
Trim Pot Location
Radio Station
Mag.
Lock
Mag. Lock
Safety ConnectorOpen CommandsGuard StationMaster/Slave
Brake
UL
Siren
Radio
Rec.
UL
Sensor
OPEN RIGHT
OPEN LEFT
Safety
Loop
Center
Loop
Obstruction
Sensor
Charger
Power
Low Battery
Motor Sensor
Hold Open
Timer
Stop
Overlap Delay
Close Open
Obstruction
Sensor
min.MAX
Overlap Delay
1.5
0
3
Radio Station
Loop Connector Open Commands Guard Station
Master/Slave
GND Close Stop Open GND Close Stop Open Gnd Fire Gnd Strike Gnd Exit Gnd Center
Gnd
Reopen Gnd UL Gnd +28v
Gnd Radio
Gnd +28v
+28v
Mag.
Lock
Fail Safe/Secure
Mag. Lock
N.C.
COM
N.O.
Charger
Power
Low Battery
Motor Sensor
Hold Open
Timer
Stop
CloseOpen
LimitLimit
30sec
60secoff
1sec
Radio
Rec.
UL
Sensor
Safety
Loop
Center
Loop
Brake
UL
Siren
Obstruction
Sensor
min. MAX
Overlap
Delay
1.5
0
3
Mag.
Lock
Fail
Safe/Secure
Hold Open
Timer
Stop
Close Open
30
60
Off
1
Radio
Rec.
UL
Sens
Safety
Loop
Center
Loop
Brake
Siren
STEP 3
Close the gate to within 6” of desired
closed position. Loosen and rotate the
cam until the Limit Switch “clicks”.
Tighten the cam.
STEP 2
Open the gate to the desired open
position. Loosen and rotate the ‘Open’
Cam until the Limit Switch “clicks”.
Tighten the cam.
Note: Open and close the gate without interruption every
time you change the adjustment.