Installation Guide

1
FIG.1
1
3
HINGE OUTLINE
6
MODEL VG06072
INSTALLATION STEPS
A. INSTALLING THE SIDE SEAL STRIP
1. Clean all glass panel edges receiving seal strips with rubbing alcohol. [SEE FIG.1]
2. Cut seal strip (#3) according to seal strip diagram. [FIG.1]
3. Install the side seal strip according to seal strip diagram, making sure that the flange is on the
inside of the shower. [SEE FIG.1]
3
1
NOTE: If the seal strips are not flat, use a hair dryer to apply minimal heat and press the seal strip back into
position.
3
MAKE SURE THE FLANGE IS
ON THE INSIDE OF THE SHOWER