Shower Enclosure Specification

MODEL VG6064
17
E5
5. Replace the wall connector (#9) onto the
plate. Replace the structural arm (#6).
Tighten all set screws with the hex key
supplied.
6. Install the other structural arm (#6) into
the support assembly (#22) through the
side glass panel (#16). Place the outside
plate through the hole in the side glass
panel (#16) from outside of the shower.
Place the inside plate on the other side
and screw together using the allen key
provided. Slide the structural arm over the
screw and tighten the set screw on top of
the structural arm.
Note: If not already attached to the
plates, places gaskets between the
plates and glass. Metal should not rest
on glass without gaskets.
E6
10
21
14
16
9
TIGHTEN HERE
10
14
16
22
GASKETS
22
6
6
GASKETS
OUTSIDE
PLATE
INSIDE
PLATE
SCREW WITH
ALLEN KEY
INSIDE PLATE
SCREW WITH ALLEN KEY
OUTSIDE PLATE
SET
SCREW