Installation Guide

9
MODEL VG06063
3. Place the side glass panel into the bottom
rail (#8). Use the level to position the side
glass panel correctly. Make sure the seal
strip is against the wall. Mark holes on the
wall for the mounting screws.
4. Remove the side glass panel. Drill holes into
respective marks and insert plastic anchors
(#19) inside them. Not necessary if
installing into studs. Studs are the
preferred means of installation, anchors
can pull out of the wall causing property
damage and bodily harm.
5. Replace the side glass panel back into the
bottom rail and screw it to the wall with 1
5/8" screws (#16). If the panel is not level
from the end, adjust the position of the glass
supports (#6) on the glass. This being level
is imperative to the installation. Repeat
steps 1 through 5 for the other side glass
panel (#4).
B3
8
19
16
8
B4
8
!
19
B5
6
THIS SIDE
MUST BE
LEVEL