Installation Guide

8
MODEL VG06063
GLASS
SUPPORT (6)
GASKET
SIDE GLASS PANEL
HEX SCREW
VIEW FROM THE TOP
WALL
SCREW (16)
OUTSIDE OF
SHOWER
INSIDE OF
SHOWER
1. Install the side seal strip (#5) to the wall side
of the side glass panel (#4). Make sure to
leave a 3/8" gap at the bottom.
2. Screw in the glass support (#6) to the side
glass panel using the hex key (supplied)
making sure to slide it back as far as
possible from the glass before you tighten.
The part that connects to the wall should
face in. Be sure to use gaskets on both
sides of the panel. The glass holes are
elliptical allowing for 5mm out of square.
If your shower stall is out of square
more than 5mm from the top of the glass
to the bottom of the glass then this can
cause the shower to potentially leak and
can cause potential fatal harm.
B. INSTALLING SIDE GLASS PANEL
B1
B2
THIN
GASKETS
6
OUTSIDE OF
THE CABIN
!
5
WALL SIDE
DOOR SIDE
4
3/8"
[10mm]
MAKE SURE TO
LEAVE A GAP OF
3/8" [10MM] FROM
THE BOTTOM OF
THE GLASS
5
4