Installation Guide

6
MODEL VG06063
INSTALLATION STEPS
A. INSTALLING THE BOTTOM RAIL
1. Remove the aluminum cover from the front
piece of the bottom rail by sliding it out.
2. Remove top of the corner joint. Slide the
bottom corner joint (2 pieces) (#10) onto
the bottom rail (3 pieces) (#8).
3. Align the bottom rail and corner joint to the
desired position on the shower base. Prior
to drilling, dry fit everything making sure
that everything is straight, level and plum.
Distance "A" and "B" should be the same
distance from the corner of the wall to the
bottom rail. Pre-drill for sinkers and tap
sinkers. Cut excess sinker off with
hacksaw or sharp blade. Dip screws in
silicone and screw corner joints and rails
down. Silicone tops of screws.
A1
OUTSIDE
INSIDE
ALUMINUM COVER
A
B
17
A2
8
10
THIS EDGE LOOKS
OUTSIDE OF THE SHOWER
THIS EDGE LOOKS
INSIDE OF THE SHOWER
TOP REMOVES TO
INSTALL 3/4" SCREW
A3