Installation Guide

MODEL VG06063
15
9
12
14
THIS SIDE MUST
LOOK INSIDE
THE CABIN
MAKE SURE TO
MEET THE
BOTTOM OF THE
GLASS
14
3. Make sure the doors are level from the end.
If the doors are not level, adjust the hinge
positions until the doors are level. These
being level is imperative to the installation
and will guarantee a tight seal.
4. Clean the door glass panels (#12) edges
where the door magnetic seal strips (#9)
and the door bottom seal strips (#14) are to
be installed with rubbing alcohol. Cut the
seal strips according to the diagram. They
are pre-cut already but you may have to cut
more to have it fit properly as displayed in
the diagram. Verify that the lips of all seal
strips face toward the inside of the shower
cabin before seal strip installation. Install
the seal strips according to the diagram.
NOTES:
1. If the seal strip is not flat and is twisted, soak
the strip in hot water and press the seal strip
back
into position.
2. Cutting/finishing is needed but only after fully
installing and only at the top of the unit.
E3
THIS SIDE
MUST BE
LEVEL
12
E4