Installation Guide

14
MODEL VG06063
!
INSIDE VIEW
CLEAR
PVC SHIMS
HINGE (8)
DOOR
PANEL (13)
INSIDE VIEW
DOOR
PANEL (13)
HINGE (8)
CLEAR
PVC SHIMS
E2
E1
E. INSTALLING THE DOOR
1. Clean the door (#12) glass surfaces
where the hinges (#7) are to be installed
with rubbing alcohol. Do not install the
handle first, this is dangerous and may
cause the glass to break. Install the top
hinge first for safety and ease of install.
Position the door onto the hinges. Place
a thin gasket (supplied) on each side of
the door between the glass and hinge
while holding the door in place. Hold
securely in place using shims. The seal
(#13) may get stuck between the two
panels of glass. Pull the seal out of the
groove using your fingers and nothing
sharp, making sure not to damage the
seal. Install the hinges as illustrated.
Use the allen key supplied. Tighten hex
screws.
2. Adjust hinge so the gaps are equal at top
and bottom and pull door panel away
from side panel to allow the door to swing
freely without crimping seal strip (#13).
Lift door panel to be level with hinge
panel. Use PVC shims provided to hold
firmly in place. NOTE: When the door
is installed make sure the gap between
the door and the side panel is even
from top to bottom. You may need to
add more than one shim per hinge as
glass hole openings vary during
production. PVC shims prevent the
door from sagging due to gravity and
the weight of the door. Never install
without shims, this can cause the
glass to break causing property
damage and bodily harm. Repeat
steps 1 and 2 to attach the hinges to the
other door.
WARNING
!
DOOR PANEL INSTALLATION REQUIRES
TWO OR MORE PEOPLE TO ASSIST
HEX SCREW
SIDE
GLASS
PANEL (4)
DOOR (12)
THIN
GASKETS
HINGE (7)
OUTSIDE OF
THE CABIN
INSIDE OF
THE CABIN
PLATE
VIEW FROM THE TOP
VIEW FROM
INSIDE
THIS SIDE
MUST BE
LEVEL