Installation Guide

12
13
THIS SIDE MUST
LOOK INSIDE
THE CABIN
MAKE SURE TO
MEET THE
BOTTOM OF THE
GLASS
13
MODEL VG06063
1. Clean the door glass panels (#12) edges
where the door side seal strips (#13) are to
be installed with rubbing alcohol. Place the
seal strips according to the diagram. Verify
that the lips of all seal strips face toward
the inside of the shower cabin before seal
strip installation.
NOTES:
1. If the seal strip is not flat and is twisted, soak
the strip in hot water and press the seal strip
back into position.
2. Cutting/finishing is needed but only after
fully installing and only at the top of the unit.
D1
D. INSTALLING THE DOOR SIDE SEAL STRIPS
THIS SIDE
MUST LOOK
INSIDE THE
CABIN
13 13
THIS SIDE
MUST LOOK
INSIDE THE
CABIN
13
12