Use and Care Manual

7
MODEL VG06046
PLATE
2
4
4. Remove the rail from the dry fit and remove
the wall mount brackets (#2) from the
structural rail (#4).
5. Line the outside of the wall mount brackets
with the markings on the wall. With the
plates still installed to the wall mount
brackets mark the wall at the center of the
holes of the plate. Note: It is important to
perform a dry fit prior to install. Once
everything is level and plumb then you
can begin your drilling.
A4
2
MARK THE TWO
HOLES ON THE
WALL WITH A
PENCIL
2
A5
!
A6
1
1
6.
Drill holes where you marked the walls and
place plastic anchors (#1) inside them.
Preferred method of installation
negates anchors and has the installation
going right into studs.
There is a 7mm
adjustment
built into each plate.
7mm