Technical information

V1.0 Vig625M Motherboard Manual
17
K – Clear CMOS jumper
This allows you to clear the CMOS of the Motherboard when moving the jumper from
pins 1-2 to 2-3.
L – Serial ATA II Connectors
Can connect up to 4 SATA devices (Hard Disk Drive, CD-ROM)
M – Front Panel Connector 1
Controls the Hard Disk Drive LED, Power Switch, Reset Switch and Power LED
N – Front Panel Connector 2
Controls the Speaker and Power LED
O – USB header
Allows up to 2 USB devices to be connected to each USB header
P – USB header
Allows up to 2 USB devices to be connected to each USB header
Q – S/PDIF-Out Connector
This connector is used to connect S/PDIF (Sony & Phillips digital Interconnect Format)
interface for digital transmission.
R – Floppy Connector
This connector allows you to connect a floppy drive to the chassis.
S – Front Panel Audio Connector
This header supports HD Audio which allows the Motherboard to support front panel
Audio.
T – CD-In Connector
This connector is provided for external audio input.
U – PCI Slot 32bit
The PCI slots support LAN cards, USB cards and other add-on cards that comply with
PCI specifications.
V – PCI Express x1 Slot
PCI Express x1 supports up to 250 MB/s
W – PCI Express x16 Slot
PCI Express x16 supports up to 4.0 GB/s transfer rate.
X – Chassis Intrusion
Notifies before entering OS that the Chassis panel may have been tampered with.
Y – Serial Port Connector
This connector allows you to connect a serial device to the chassis