System information

Vig580s Motherboard Manual
13
K – DIMM Channel A & B Sockets
This allows up to 4GB of DDR2 RAM to be installed. Up to 1GB of RAM in each slot.
L – Processor fan connector
Allows for the processor fan to be connected. The fan header is PWM compliant.
M – I/O controller
Handles all the input/output signals to and from the Motherboard.
N – FAN Header
Controls System FAN depending on system load and temperature.
O – Floppy drive connector
This allows a floppy drive to be added to the Motherboard. The port is slotted to
ensure correct installation.
P – Parallel IDE (P-ATA) connector
This allows up to 2 devices, such as CD/DVD drives and hard drives to be added
to the IDE channel. The port is slotted to ensure correct installation.
Q – Power connector (24 way ATX2.2)
This is the main power connector.
R – 4 Mbit Firmware Hub (FWH)
This is an optional feature which is not offered by Viglen
S – Serial ATA (S-ATA) connectors
This allows for up to 4 devices. One device can be installed on one S-ATA connector
on the Motherboard running at 300MB/s.
T – Front panel connector
This is the panel to which the case cables are connected, such as the power switch.
Power LED etc.
.
U – Intel ICH7
V – Front panel USB connectors
This allows an additional 2 USB ports to be added with the use of a cable.
W – Front panel USB connectors
This allows an additional 2 USB ports to be added with the use of a cable.