System information

Vig566s Motherboard Manual

Figure 7: Floppy Drive Connector

PCI IDE Connector (40-1 pin PRI_PCIIDE1)

This connector is for an Ultra DMA 133/100/66 signal cables. The IDE connector

supports up to two IDE devices (optical drive and hard disk drive).

Note:

? Pin 20 on the IDE connector is removed to match the covered hole on the Ultra

DMA cable connector. This prevents incorrect insertion when you connect the

IDE cable.

? Use the 80-conductor IDE cable for Ultra DMA 5 (ATA100/66) IDE devices.

? The system automatically assigns the boot sequence of ATAPI devices

connected to the PCI IDE connector.

Figure 8: PCI IDE Connector