User guide

Viglen IX2000 Chassis User Guide
25
Installing Hard Drives to the Non Hotswap Cage
1. Find the special mounting screws supplied with the server (See Figure 18).
Figure 18: Special Mounting Screws
2. Put the hard drives into the cage and align with the mounting holes (See Figure 19).
3. Secure the hard drives to the drive cage using the screws shown in Figure 18.
Figure 19: Mounting Holes on the Drive Cage
Removing the Hotswap or Non Hotswap Cage
1. Loosen the four thumbscrews, which secure the hard disk drive cage to the chassis
body.
2. Pull out the hard disk drive cage slightly (See Figure 20).
Figure 20: Pulling out the Cage slightly