Specifications

• Jumper settings
CAUTION Do not move any jumpers with the power on. Always turn off the power and unplug
the power cord from the computer before changing a jumper setting. Otherwise, the board could
be damaged.
Figure 5. Motherboard jumper.
BIOS Setup Configuration Jumper (J6J2) Settings
The 3-pin jumper block determines the BIOS Setup program's mode. The table below describes
the jumper settings for the three modes: normal, configure, and recovery. When the jumper is
set to configure mode and the computer is powered-up, the BIOS compares the processor
version and the microcode version in the BIOS and reports if the two match.
Table 4.
V1.0 Page 9 of 17
Function/Mode Jumper Setting Configuration
Normal 1-2
1
3
The BIOS uses current configuration information and passwords for
booting.
Configure 2-3
After the POST runs, Setup runs automatically. The maintenance menu
is displayed.
Recovery None
The BIOS attempts to recover the BIOS configuration. A recovery
diskette is required.