User guide

EQ100 Motherboard User Guide V2.0

V – Front panel USB connectors

This allows an additional 2 USB ports to be added with the use of a cable.

W – Battery

The battery keeps the CMOS memory when the system isn’t turned on.

X – Front panel USB connectors

This allows an additional 2 USB ports (connected to the front facing USB ports) to be

added with the use of a cable.

Y – 1394a controller

Onboard IEEE 1394a controller.

Z – USB device wake-up jumpers

These Jumpers allow front facing USB devices to wake the computer from S1 sleep

state.

AA – Front panel IEEE 1394a connectors

This allows a IEEE 1394a port to be added with the use of a cable.

BB – Standby power LED

This green LED lights up to indicate the System is on, in sleep mode or in soft-off

mode. It acts as a reminder to shut down the system and unplug it before removing

or adding any motherboard component.

CC – SPIDIF_OUT (not supported)

This is an optional feature which is not offered by Viglen.

DD – Aux/CD internal audio connector

Allows the audio from the CD-ROM to be run though the internal audio via an

analogue cable.

EE – Front Panel Audio Connector

This connector allows for the use of front facing audio in a desktop chassis. The

connector allows the signal to be passed through from the rear connector to the front

connector.

FF – Realtek ALC882M audio codec

Decodes different audio formats.