Datasheet

© Copyright 2009 Vigitron, Inc.
Technical Specification**
*It is recommended not to exceed 750 ft. (228 m) when using with digital equipment.
**Specifications subject to change without notice.
Electrical
Video Format NTSC, PAL, SECAM
Frequency DC to 10 MHz
Coax 75 Ohm
Twisted Pair 100 Ohms +/- 20%, 24 AWG minimum
up to 1,000 ft. (305 m)
* unshielded Category 2-7
Insertion Loss 0.3 dB
CMRR 60 dB
Power No power required
Connectors Video: Male BNC
UTP: Terminal block
Transient Immunity ANSI/IEEE 587 C62.41
Environmental
Humidity 0 to 95%, non-condensing
Temperature Operating: -10°C to +70°C
Storage: -30°C to +70°C
Mechanical
Dimensions 1.26x0.94x0.55 in., 3.2x2.4x1.4 cm
Weight 0.2 oz, 20 g
Material ABS plastic, UL rating of 94V-0
TEL [phone] • FAX [phone]
13906 Sparren Ave. San Diego, CA 92129, USA • [e-mail] • www.vigitron.com
Ordering Information
PART No.
Description
Vi1003M Video balun w/ M ale BNC
System Configuration
0.55"
1.26"
0.93"
0.59"
VI1003M
1
Vi6100VR/Vi6200VR
4
Vi6104/Vi6204
8
Vi6108/Vi6208/Vi6308
16
Vi6116/Vi6216/Vi6316
32
Vi6132/Vi6232/Vi6332
Active Receivers
Channels
2,000 ft. (610 m) for Vi6200 series
1
4
8
16
32
750 ft.
228 m
Vi1004
Vi1008
Vi1016
Vi1032
VB1001F/M
VB1007M
Vi1001F/M/P
Vi1003M
Vi1006M
3,000 ft.
915 m
Maximum Cable
Distance
Passive Transceivers
ModelModel
Channels
Wire and Cable Recommendations
The Vigitron products are designed to be used with unshielded twisted pair (UTP) wiring. The UTP wire must be 24AWG - 12AWG or Category 2-7 cable.
Multi pair cable with an overall shield is acceptable, however individually shielded pairs should be avoided. Multiple UTP video feeds can be operated in
the same communication cable along with telephone, computer, control signals and low power voltages. While UTP video may be routed through
punch-down block terminals, any resistive, capacitive or inductive devices (such as T-taps or MOV's) must not be used. Please contact Vigitron for more
specific information regarding wire types and proper installation techniques.