Installation Instructions
8 Installation InstructionsVisit the ViewZ USA website at http://www.viewzusa.com
CM 308 series
Leveling Pole (Bottom & Middle)
Rotation
Installation
1) You can ensure the pole is properly aligned by tightening the lock
screws/nuts between middle & bottom poles.
2) Place a level on poles (middle & bottom) and tighten the screws/nuts
(see illustration on the right).
3) Check and adjust 2 adjacent sides of the pole until it is plumb in each
direction.
1) Hold the lower pole (where it connects to the monitor) and turn
two lock screws counter-clockwise to loosen the VESA plate (see
illustration on left below). Then, rotate vesa plate to set the position.
2) Once set in a desired position, lock the two lock-screws by turing
clockwise.
Le Loosen
Hold vesa plate posion
and turn two lock-screws as
clockwise to set the posion
Hold lower pole secon, turn
two lock-screws as counter-
clockwise to rotate vesa plate
Right Tighten
O M8 x L50 Screws
F Boom Pole
P M8 Lock Nut
E Middle Pole
Q Open Wrench