User`s manual

58
Figure 15. Exception Handle Menu
11. Select the Schedule tab. Set the schedule of when you want video loss detection to be enabled.
Schedule can be set for all week or any day of the week with up to 8 time periods per day.
12. Click the Apply button to finish.
13. Repeat above for other channels.
Setting Exception
Setting exceptions allow the DVR to alert you when irregular events occur. These events include:
• HDD Full: All installed HDD are full.
• HDD Errors: Errors occurred during writing of the HDD or HDD had failed to initialize.
• Network Disconnected: Disconnected network cable.
• IP Conflicted: Conflict in IP address setting.
• Illegal Login: Wrong user ID or password used.
• Video Exception: Instable video signal detected.
• Mismatched Output Standard Mismatch: I/O video standards do not match.
To set exceptions:
1. Enter the Exception menu by clicking Menu > Exception.
2. Select the exception to configure under Exception Type.
3. Select triggering options, as shown in Figure 16. Trigger options are further explained in the next
section (See Understanding Exception Trigger Options).