Instruction manual

Model ID
You can control this monitor with “Monitor control” software and “Model ID” functions.
Available controls are Turn on, Turn off or change the input source of this monitor.
1. Connect the PC and Monitor(s) with RS-232 Cable. The PC and Monitor(s) have to be turned on.
2. Install the “Monitor Control” software using an enclosed CD.
1) Insert the CD into the PC and open the CD-ROM drive folder.
2) Copy the “Monitor Control” icon and paste it on the screen of the PC.
3) Double click the icon.
3. Monitor Control
1) Port Set: Click the “Connect”.
- Com Port: Can be set up from Com1 to Com6.
- Baud rate: Can be set up form 600 to 25600.
- Data bit: Can be set up from 5 to 8 bit.
- Parity bit: Can be set up as None, Odd, Even,
Mark or Space.
- Stop bit: Can be set up as 1, 1.5 or 2bit.
- Flow control: Can be set up as None,
DTR/DSR, RTS/CTS or
Space.
INSTRUCTION MANUAL ………………………………………………………………………. 15