User`s guide

7
3-2-1. Video input
• The video is displayed when you connect the camera or video signal into VIDEO input.
3-2-2. Pattern signal out & Loop Through video out
• Select Pattern Out ON when you check the wiring status, monitor and DVR.
• When the Pattern Out is off, you can see the video by looped through output.
3-2-3. VGA input
• Check the video output in XVGA (1024× 768/60Hz) from DVR or from PC.
• It supports XVGA in maximum and a higher resolution may not displayed in normal.
3-2-4. PTZ&OSD control through RS-485
• Through RS-485 com. port, you can control PTZ Receiver and/or SPEED DOME CAMERA. It
supports various protocols and it is possible to add new protocol upon request.
3-2-5. CVBS video signal level meter
• It displays CVBS video signal level of SYNC (Brightness/A.Level) and BURST
(Color/F. Level) in percentage (error: ± 2%).
3-2-6. PTZ&OSD control through COAX cable
• Through Coax com. port, you can control SPEED DOME CAMERA.
4. Menu Setting
4-1. MENU mode
4-1-1. SELECT MENU
- It displays the main menu as below when you press the SET MENU button.
- Press the direction buttons to mode Up ▲, Down ▼, Right ▶ or Left ◀.
The menu mode is automatically off if you don’t press any buttons for few minutes.
SELECT MENU
SETUP MENU MODE
ANGLE MENU MODE
RS485&COAX MODE
PATTERN OUT OFF
LEVEL-METER ON
EXIT
▲▼: MOVE SET: SELECT
• SETUP MENU MODE: You can select the video input (CVBS /VGA) and adjust
the brightness, contrast and sharpness.
• ANGLE MENU MODE: It displays the guideline zone to adjust the camera angle.
• RS485&COAX MODE: You can control the PTZ receiver and/or speed dome
camera through RS-485 port.
• PATTERN OUT OFF: You can put out the Pattern Color bar to check the wiring
status, monitor and DVR.