User manual

Hybrid Portable Test Monitor
11
• Contrast:Toadjustthecontrastrange(0~100steps)
• Brightness:Toadjustthebrightness(0~100steps)
• Hue:Toadjustthecolour(0~100steps)
• Saturation:Toadjustthechroma(0~100steps)
• Picture Mode: Standard > Movie > Vivid > User
Thevalueofeachmodechangesautomatically
• Scale:Toadjustthescreenratio(Full>4:3>Zoom1>Zoom2>16:9)
• Reverse:ToreversetheupperandlowersidesoftheLCDscreen.
4-1-1-2. ANGLE MODE
Indicationlines:Toadjusttheviewinganglesbasedonaspecicarea.


• SelectingANGLEMODEdisplaysagreenboxandthecameraanglezoneindicationlines.
• PresstheSETMENUbuttontoselectthesizeofthegreenbox.PresstheSETMENUbuttonagain
andselectthesidelinesoftheboxyouwanttoadjust,andpressthe///buttonstoset
thepositionofeachline.
• ToexitANGLEMODE,presstheEXITKEY.




4-1-1-3.RS485&COAXMODE(PTZ/OSDControl)
• MODE:InRS-485TxandCOAXmodeyoucancontrolthePTZ&CameraOSD.InRx.mode,it
receivesthePTZcontroldata(asHEXvalues)anddisplaysthedataonthemonitor.InAnalyser
mode,itanalysestheprotocolsreceivedthroughtheRS-485portanddisplaystheHEXvalueand
command.
• PROTOCOL:Toselecttheprotocoloftheequipmentwhichyouwanttocontrol.
• ADDRESS:Toselecttheaddressoftheequipmentwhichyouwanttocontrol.
※InCOAXmode,youcancontrolthecameraregardlessoftheaddress
• BAUDRATE:Toselectthecommunicationspeed(2400,4800,9600,19200,38400).
※InCOAXmode,youcancontrolthecameraregardlessofthebaudrate
• START:Tostartcontrollingthedeviceaftersettingalltheabovemenus.
• EXIT:ToexitfromMENUMODE