Instruction manual

13
CVBS (& S-Video) Mode
Press the MENU button to display the Main Menu.The follow setup menu will appears.
Volume, Contrast, Brightness
Change the Volume, Contrast & Brightness according to personal preference.
Color
used to minutely adjust color.
Tint
adjusts all the colors on the screen, but is most noticeable to the eye in reds and yellows, And is also usually
set for pleasing face tones. (Appears in NTSC mode only).
Sharpness
sets the desired sharpening enhancement to the picture.
Advanced
Under Scan Adjusts the image size. (ON/OFF)
TNR (Temporal Noisy Reduction) strength is activate this feature to reduce any noisy signal that may
appear on the screen (LOW/Mid/High).
Filter is used enable or disable the Luminance Filter function
L/L Mode choose ON/OFF function reinforce the L/L (line Lock) function
* It is recommended to use this function if there are some twisting vertical line with Line-Lock camera.
Color is select picture Color level (Neutral/VIVID/Individual)
Dynamic Control is option to enhance the contrast of the image.
This feature makes the color much darker and brighter
Color Temp is used to control color temperature ( R / G / B )
Recall the monitor original factory setting
Main Menu
Volume 0
Contrast +62
Brightness +70
Color +64
Tint 0
Sharpness +6
Advanced ►
OSD Menu ►
Source CVBS1
Advanced
Under scan OFF
TNR strength Mid
Filter Off
L/L Mode Off
Color ▶
▶▶
▶
Dynamic Contrast ▶
▶▶
▶
Color Temp ▶
▶▶
▶
Recall No
*LCD Panel Frequency Setting(NTSC:60Hz or PAL:50Hz)
MENU + ► (Multi Push - Over 3sec) : Panel 50Hz After setting then DC jack put off and put on
MENU + ◀ (Multi Push - Over 3sec) : Panel 60Hz After setting then DC jack put off and put on
*LCD Panel Frequency Setting(NTSC:60Hz or PAL:50Hz)
MENU + ► (Multi Push - Over 3sec) : Panel 50Hz After setting then DC jack put off and put on
MENU + ◀ (Multi Push - Over 3sec) : Panel 60Hz After setting then DC jack put off and put on