Instruction manual

10
Connections
To make a normal connection to the monitor, bring a cord from a camera, or other video
Source to one of the BNC jacks or from a PC to the PC jack on the back of the monitor.
Either the left or right BNC jack can be used for input. The other jack may be optionally connected to another
user of the same signal.
Auto Termination The input circuit of the monitor normally terminates the incoming
Cable in 75Ω but these BNCs jack are auto-terminating. When two cables are connected, the internal
termination is switched out, letting the final destination.
Equipment provide the end termination. This arrangement is also specially offered for the Y/C (S-Video)
jacks.
* Supplied item
LCD monitor
Power supply unit (DC 12V) / Power cord
VGA cable
Operating instructions manual