User manual

14 EN UltraView Color TFT LCD monitor 15 in./ 17 in./ 19 in./ 20 in.
Connecting a video signal to the monitor
Figure 2 Input/Output interface
1
DC IN connector: Plug head of power cord into a wall socket.
2
DC OUT: 12 VDC, maximum 1 A
3
VGA IN: Connect to an analog RGB output terminal, such as the display card
output VGA terminal of the personal computer.
4
DVI IN: Connect to an analog RGB output terminal, such as the display card
output DVI terminal of the personal computer.
5
VIDEO IN/OUT (BNC type): Connect to the output/input terminal of video
equipment, such as a VCR or a color video camera.
6
Y/C IN/OUT (4-Pin mini-Din): Connect to the Y/C output/input terminal of
camera, VCR, or other video equipment.
7
AUDIO IN/OUT (RCA jack): Audio input/output terminal.
For all channels: When you select a video signal screen without connecting any
video signal, the message "No Signal" appears on screen. While playing a video,
and when the video signal is lost, the message "Video Loss" appears on screen.
Note: It takes about 2 to 3 seconds to change mode. When the mode is changed, the monitor
shows a blue screen then enters signal input, or shows the message “No Signal”.