User`s manual

Release Notes Kaleido-Alto/Quad/Quad-Dual Version 3.31
2 Part Number: M785-0203-115 Updated: 3 October 2008
Version 3.31
Fixes
• (B19597) The WSS information present on 625-line analog video signals is not decoded.
Version 3.30
New Features
• Support for the AFD (Video Index), WSS, and AFD (SMPTE 2016) video format descriptors.
• Automatic aspect ratio conversions: a video monitor’s aspect ratio can be slaved to the input format; a
video raster’s aspect ratio can be set to follow AFD/WSS indicators.
• Support for bidirectional (v.g. Arabic) input in text labels and UMD text.
• Support of DVI input trough the use of the KXI-DVI-Bridge device connected upstream to a Kaleido-
Alto/Quad input.
• Two new input resolutions: 1080p 29.97Hz, and 1080p 23.98Hz.
• Ability to synchronize the unit’s internal clock to an external NTP source.
Fixes
• (B9422) When using the optional Monitoring Output card in 10×1 mode to monitor an HD signal,
switching to scan converter mode and then going back to 10x1 mode will make the signal disappear.
• (B14794) When using timing offsets larger than 15 hours you need to enter a different value in KEdit in
order to obtain the proper offset on the Kaleido-Alto/Quad/Quad-Dual.
• (B15215) The <setKAudioOut> Gateway command does not work with input 10, neither for embedded
nor for audio card inputs.
• (B18263) Alarms from the right embedded audio channel are not reported.
• (B18862) In a cascaded system, after opening the System Status, Audio Settings, or Video Settings
window on the master unit, alarms from the slave units are not reported anymore.
• (B19046) Every action triggered by an Alarm Monitor could be performed repeatedly, if one of the actions
involves loading a Layout.
• (B19099) GPI Out actions assigned to GPI Output 10 do not work.
Version 3.21
New Features
• Additional status information about the network configuration (DHCP or static IP address).
Fixes
• (B14426) After a change of resolution or a layout export, the Kaleido-RCP and the Kaleido-
Alto/Quad/Quad-Dual may stop communicating with each other.
• (B14239) Overscan mode is not available with HD sources.
• (B15216) Analog audio “Gain” control is not functional.
• (B15215) An audio monitoring selection using a remote control command from the “Gateway” is not
functional.
• (B9276) The following remote control commands from the “Gateway” do not send an ACK response:
<openID>IP_ADDRESS_0_4_0_0</openID>
<openID>IP_ADDRESS</openID>
• (B15473) It is possible to make audio monitoring selections that conflict with each other.
• (B15450) There are problems with short Ethernet cables (now any cable length is supported).