Service manual
Table Of Contents
- VP171sb-1.pdf
- VP171 Series Service Manual
- Preface
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Mechanical Construction
- Chapter 3 Procedure of Disassembly
- Chapter 4 Troubleshooting Procedure
- Chapter 5 RMA Inspection Standard
- Chapter 6 Function Test and Alignment Procedure
- Chapter 7 Firmware Upgrade Procedure
- Chapter 8 DDC Key In Procedure
- Chapter 9 Panel Specification
- Chapter 10 Packing For Shipping
- Chapter 11 Appendix
- VP171sb-1.pdf
- Preface
- Flowchart for Repair
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Mechanical Construction
- Chapter 3 Procedure of Disassembly
- Chapter 4 Troubleshooting Procedure
- Chapter 5 RMA Inspection Standard
- Chapter 6 Function Test and Alignment Procedure
- Chapter 7 Firmware Upgrade Procedure
- Chapter 8 DDC Key-In Procedure
- Chapter 9 Panel Specification
- Chapter 10 Packing For Shipping
- Chapter 11 Appendix
- Reader's Response
- VP171 -page 11 only.pdf
- VP171 Series Service Manual
- Preface
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Mechanical Construction
- Chapter 3 Procedure of Disassembly
- Chapter 4 Troubleshooting Procedure
- Chapter 5 RMA Inspection Standard
- Chapter 6 Function Test and Alignment Procedure
- Chapter 7 Firmware Upgrade Procedure
- Chapter 8 DDC Key In Procedure
- Chapter 9 Panel Specification
- Chapter 10 Packing For Shipping
- Chapter 11 Appendix
- VP171 -page 11 only.pdf
- VP171 Series Service Manual
- Preface
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Mechanical Construction
- Chapter 3 Procedure of Disassembly
- Chapter 4 Troubleshooting Procedure
- Chapter 5 RMA Inspection Standard
- Chapter 6 Function Test and Alignment Procedure
- Chapter 7 Firmware Upgrade Procedure
- Chapter 8 DDC Key In Procedure
- Chapter 9 Panel Specification
- Chapter 10 Packing For Shipping
- Chapter 11 Appendix
- VP171 -page 11 only.pdf
- VP171 Series Service Manual
- Preface
- Table of Contents
- Chapter 1 Introduction
- Chapter 2 Mechanical Construction
- Chapter 3 Procedure of Disassembly
- Chapter 4 Troubleshooting Procedure
- Chapter 5 RMA Inspection Standard
- Chapter 6 Function Test and Alignment Procedure
- Chapter 7 Firmware Upgrade Procedure
- Chapter 8 DDC Key In Procedure
- Chapter 9 Panel Specification
- Chapter 10 Packing For Shipping
- Chapter 11 Appendix
3-4 Disassembly of Front Cover Module, LCD Panel, Switch
and Inlet Wires
3
Inlet Wire
Switch
Wire
2. Unscrew one screw that secures Inlet Wire and disconnect two wires that are connected to Switch Wire.
3. Use the tool to pull and press out Inlet and Switch Wires.
2
X 1
1
1. Remove two tapes of Control Board wire and detach Front Cover from LCD Bracket.
Control Board wire
Front Cover
85.1C124.060
ViewSonic Corporation
23
Confidential – Do Not Copy
VP171/b/s