Service manual

5-1.5.2 Auto Image Adjust

Please select and enter “Auto Adjust” function on Main Menu to

see if it is workable. The “Auto Adjust” function is aimed to offer

a better screen quality by built-in ASIC. For optimum screen quality, the

user has to adjust each function manually.

5-1.5.3 Firmware

Test Pattern: Burn in Mode (Refer to Chapter III-3. Hot Keys for Function

Controls) - Make sure the F/W is the latest version.

5-1.5.4 DDC

Test Pattern: EDID program - Make sure it can pass test program.

5-1.5.5 Fine Tune and Sharpness

Test Signal: 1280 x 1024 @ 60.0kHz

Test Pattern: Line Moiré Pattern

- Check and see if the image has noise and focus performs well. Eliminate

visual line bar.

- If not, readjust by the following steps:

(a) Select and enter “Auto config” function on “Auto Adjust” to

adjust the image to eliminate visual wavy noise.

(b) Then, select and enter “Sharpness” function to adjust the clarity and

focus of the screen image.

5-1.5.6 White Balance

Test Signal: 640*480@60Hz

Test Pattern: Full White and Black Pattern

5-1.5.7 R, G, B, Colors Contrast

Test Signal: 1280 x 1024 @ 60.0kHz

Test Pattern: R, G, B, Color Intensities Pattern and 16 Gray Scale Pattern

- Check and see if each color is normal and distinguishable.

- If not, please return the unit to repair area.

5-1.5.8 Screen Uniformity and Flicker

Test Signal: 1280 x 1024 @ 60.0kHz

Test Pattern: Full White Pattern

- Check and see if it is in normal condition.

ViewSonic Corporation Confidential

Do Not Copy Q9-1_Q9b-1