User Guide

51
Function Description
Audio Settings See "Adjusting the sound" on page 42 for details.
Presentation
Timer
See "Setting the presentation timer" on page 32 for details.
Pattern
The projector can display several test patterns. It helps you
adjust the image size and focus and check that the projected
image is free from distortion.
Blank Timer See "Hiding the image" on page 33 for details.
Message
Selecting On displays the current information on the screen
when the projector is detecting or searching for a signal.
Splash Screen
Allows you to select which logo screen will be displayed
during projector start-up.
My Button Sets a hotkey on remote control.
3D Settings
See "Depending on the connected device, the CEC function
may not work." on page 34 for details.
HDMI Settings See "Changing HDMI input settings" on page 24 for details.
LAN Settings
See "Controlling the projector through a LAN environment"
on page 35 for details.
Lamp Settings
Lamp Mode
See "Setting Lamp Mode" on page 56 for details.
Reset Lamp Hours
Resets the lamp timer after new lamp is installed. For
changing the lamp, please contact qualified service personnel.
Lamp Hours
See "Getting to know the lamp hour" on page 56 for details on
how the total lamp hour is calculated.
Filter Settings
See "Using the dust filter (optional accessory)" on page 54 for
details.
DCR
Enables or disables the DCR (Dynamic Contrast Ratio)
function. Selecting On enables the function and the projector
will automatically switch the lamp mode between normal and
economic modes according to the input image detected.
This function is only available for PC timings from a
VGA or HDMI input signal.
After enabling DCR, frequent lamp mode switching may
shorten lamp life and noise level will vary during
operation.
4. BASIC menu
5. ADVANCED menu