User Guide

77
APPENDICE II
Protocollo RS-232C
Impostazioni RS232
Velocità in baud 9600
Bit di dati 8
Controllo parità Nessuno
Bit di stop 1
Controllo di flusso Nessuno
UART16550 FIFO Disattiva
Ritardo minimo per il comando successivo: 1 ms
Struttura del comando di controllo
Il comando è strutturato da codice intestazione, codice comando, codice dati e
codice finale. La maggior parte dei comandi è strutturata, fatta eccezione per alcuni
problemi di compatibilità con altri proiettori.
Codice
intestazione
Codice di
comando
Codice dati Codice finale
HEX Command Data 0Dh
ASCII ‘V’ Command Data CR
Comandi operativi
Nota:
"CR" è l'acronimo di ritorno a capo
XX = 99
Esempio: S99S001 + Enter per accendere.
Risultato di ritorno P=Superato / F=Fallito
n: 0:Disable/1: Abilita/Valore (0 - 9999)
Gruppo comandi 00
ASCII HEX Funzione Descrizione
Risultato di
ritorno
SXXS0001 53h Xh Xh 53h 30h 30h 30h 31h 0Dh Power On P/F
SXXS0002 53h Xh Xh 53h 30h 30h 30h 32h 0Dh Power Off P/F
SXXS0003 53h Xh Xh 53h 30h 30h 30h 33h 0Dh Resync P/F
SXXG0004 53h Xh Xh 47h 30h 30h 30h 34h 0Dh Get Lamp Hours Pn/F
SXXG0005 53h Xh Xh 47h 30h 30h 30h 35h 0Dh Get Air filter timer n=0~999999 Pn/F
SXXS0006 53h Xh Xh 53h 30h 30h 30h 36h 0Dh System Reset P/F
SXXG0007 53h Xh Xh 47h 30h 30h 30h 37h 0Dh Get System Status
0: Reset
1:Standby
2:Operation
3:Cooling
Pn/F
SXXG0008 53h Xh Xh 47h 30h 30h 30h 38h 0Dh Get F/W Version Pn/F
SXXG0009 53h Xh Xh 47h 30h 30h 30h 39h 0Dh Get Alter EMail Pn/F
SXXS0009n 53h Xh Xh 53h 30h 30h 30h 39h nh 0Dh Set Alter Email
n=xxxxxx@xxxx.
xxx.xx
P/F
SXXS0010 53h Xh Xh 53h 30h 30h 31h 30h 0Dh Lamp Hours Reset Pn/F