User`s manual

4
11. HQV
Enable image enhancement functions such as advanced motion, adaptive noise reduction,
advanced film mode detection and advanced details enhancement.
12. INPUT
Manually selects an input source.
13. HDMI
Direct access to HDMI inputs. Browse through HDMI 1 and 2 inputs.
14. S-VIDEO
Direct access to S-video input.
15. COMPOSITE VIDEO
Direct access to composite video input.
16. LIGHT
To illuminate remote control key pad backlight.
17. ASPECT RATIO
Selections of screen proportion.
18. V/H KEYSTONE
Adjust image geometry distortion digitally caused by off-center placement of projector.
19. FOUR DIRECTIONAL BUTTONS
Use four directional buttons to select items or make adjustments to your selection.
20. EXIT
To Exits the on-screen menu.
21. OVERSCAN
To push data content out of the viewing area.
22. FREEZE
Freeze the current viewing image.
23. COMPONENT VIDEO
Direct access to component video inputs. Browse through component video 1 and 2 inputs.
24. PC
Direct access to PC input.
Installing the Batteries
1. Open the battery cover in the direction shown.
2. Install batteries as indicated by the diagram inside the compartment.
3. Close the battery cover into position.
« NOTE »
• Keep the batteries out of the reach of children. There is a danger of death by accidentally
swallowing the battery.
• Remove batteries from remote control when not being used for extended periods.
• Do not dispose of the used battery along with household waste. Dispose of used batteries
according to local regulations.
• Danger of explosion may occur if batteries are incorrectly replaced. Replace all the batteries
with new ones.