User`s manual

Introduction
3
ENG
Connection ports
(1) (2) (3) (4) (5) (6) (7)
(8) (9) (10) (11)
1. RS-232 terminal
When operating the projector via a computer, connect this to the controlling computer’s RS-232C port.
2. USB terminal (Service purpose)
This connector is for firmware upgrade.
3. HDMI-1 terminal
Interface for digital video.
4. HDMI-2 terminal
Interface for digital video.
5. RGB IN terminal
Connects PC input signal (analog) to this jack.
6. COMPONENT VIDEO 1 terminals
Analog/digital video interface transmits via three separate signals - Y, Cb/Pb, Cr/Pr.
7. S-VIDEO terminal
Connects S-Video output from video equipment to this jack.
8. DC 5V terminal
9. DC 12V TRIGGER terminal
10. COMPONENT VIDEO 2 terminals
Analog/digital video interface transmits via three separate signals - Y, Cb/Pb, Cr/Pr.
11. COMPOSITE VIDEO terminal
Connects composite video output from video equipment to this jack.
Remote Control
1. POWER
Turn on or off the projector.
2. COLOR TEMP.
Selections of color shading.
3. PICTURE MODE
One-step easy access to ViewSonic customized
presets for various viewing pleasures.
4. LENS SHIFT
Motorized vertical and horizontal lens shift for
positioning display image without physically
moving the unit.
5. ZOOM/FOCUS
Motorized zoom and focus adjust.
6. ENTER
To confirm selected menu item.
7. MENU
Opens and Exits the on-screen menu.
8. DAYLIGHT SENSOR
Enable daylight sensor to automatically adjust
the best viewing condition based on ambient
light condition.
9. PCS
Enable advanced color enhancement functions
such as flesh tone correction, edge enhance-
ment, gamma correction and 3D color manage-
ment.
10. BLACK LEVEL
Defines the brightness levels at the darkest
visual image point.