User`s manual

ADVANCED OPERATION

ENG

• The lamp contains inorganic mercury. If the lamp bursts, the mercury inside the lamp will go

out of the projector. Leave the area immediately if the lamp shatters while being operated and

ventilate the area for at least 30 minutes in order to avoid the inhalation of mercury fumes.

Otherwise it could be harmful to user’s health.

To replace the lamp:

1. Loosen the two screws of lamp cover.

2. Remove the lamp cover.

3. Loosen the two screws of lamp module.

4. Pull out the old lamp module by lamp handle.

5. Mount the new lamp.

6. Replace the lamp cover.

7. Reset the lamp timer.

« NOTE »

• Dispose of the used lamp according to local regulations.

• Ensure that screws are tightened properly. Screws not tightened fully may result in injury or

accidents.

• Since the lamp is made of glass, do not drop the unit and do not scratch the glass.

• Do not reuse the old lamp. This could cause the lamp to explode.

• Be sure to turn off the projector and unplug the AC power cord before replacing the lamp.

• Do not use the projector with the lamp cover removed.